When that happens, a battery charger will come to your rescue.It receives commands from the wireless controller and sets the speed of the motors.Other development boards might also be used (NodeMCU, Firebeetle, etc.), and the principles presented in this tutorial can be applied on other models of robots and gadgets.
It connects to a Wi-Fi network and receives commands from Blynk server. A smartphone running Blynk app was used as a remote control, and different input methods were used: push buttons, sliding bars and even smartphones accelerometer. You can find more about this project here: Ive also made some experiments with voice commands. Converter Stick Full If YouIt might be usefull if you want to remotelly control a robot without using your hands, or if you want to made it accessible for someone with limited movements. ![]() A DIY robotic kit was used, along with some of my favourite tools: Adafruit.io, IFTTT and Arduino IDE. Converter Stick Full Instructions HereFull instructions here: You can use different kits or even desing your own robots using simple materials, without the need of using complex tools such as 3D printers and laser cutting machines. You can find an example on one of my previous tutorials: Step 1: Tools and Materials The following tools were used in this project: Solder iron and wire ( link link). The DC motors already came with wires soldered to its terminals. But it will eventually break and you might have to resolder it. The robot chassis I used in this project is made of aluminum, and circuit boards are installed on this metal parts. I used a layer of foam sheet between the boards and the metal plate to avoid possible short-circuits. Double sided tape. It was used for glueing the foam sheets to the circuit boards, and for the installation of the H-Bridge modue. I used the following hardware parts for my project: Arduino Uno based dev board ( link link link link). It is really easy to use and program with Arduino IDE, great for beginner on electronics and programming. This module allows the 3.3V signals from the Wemos (or an Arduino) to be amplified to the 12V needed for the motors. This awesome kit has with everything you need to built a tank: two DC motors, gears, tracks, bolts, nuts, etc. It already comes with the tools need for assembling the chassis, which is great for beginners PS2 Wireless Remote Control ( link). This videogame controller can send comands wirelessly to a receiver, which can be interfaced with an microcontrollert using serial communication. V batteries (x3) ( link link). Converter Stick Series For PoweringI used three 3.7V batteries in series for powering them. S 18650 battery holder ( link link link). It can hold three 18650 batteries in serie, and can be easilly be attached to the back of the tank.
0 Comments
Leave a Reply. |